I’m sharing Praiseworthy Prose and Path of Petals with you today. These are new SU! sets and can be found in the 2019-2020 catalog. I’m also participating in a challenge with Hand Stamped Sentiments, #HSSIC 316
I started by taking an 11 X 4 1/4 inch piece of Rococo Rose cardstock and scoring at 5 1/2 inches to make a card base.
Second, I embossed a panel of Rococo Rose cardstock with the Tufted Embossing Folder and adhered it to the card front with SNAIL adhesive.
Third, I added a layer of the Pressed Petals DSP to the top layer and adhered with SNAIL adhesive.
Fourth, I took a different patterned piece of the Pressed Petals DSP and matted it with Rococo Rose cardstock. Next, I adhered the layered piece across the card front with SNAIL adhesive.
Fifth, I cut a strip of the Noble Peacock DSP (Old Olive) and angled the edges into a banner. Next, I adhered this layer to the Pressed Petals DSP strip with SNAIL adhesive.
Sixth, I cut a piece of Rococo Rose cardstock with the Petal Labels Dies (Decorative Oval). Next, I stamped a sentiment from Praiseworthy Prose onto Very Vanilla cardstock with Rococo Rose ink. Following, I cut a piece of Very Vanilla cardstock with the Petals Labels Dies (Oval). Then, I adhered these two layers together with SNAIL adhesive. Afterwards, I adhered the layered piece over the Noble Peacock DSP strip with Stampin’ Dimensionals .
Seventh, I tied a bow using the Mossy Meadow Linen found in the Magnolia Lane Ribbon Combo Pack. Next, I adhered it in the lower corner of the stamped sentiment with a Glue Dot. Then, I placed an Antique Gold Designer Element over the center of the bow.
Eighth, I stamped the limb image from the Path of Petals stamp set with Old Olive ink onto Very Vanilla cardstock. Next, I randomly stamped flowers from the Path of Petals stamp set with Rococo Rose and Daffodil Delight inks. Then, I adhered the stamped piece inside of the card with SNAIL adhesive.
Card Base-Rococo Rose cardstock-11 x 4 1/4 inches, scored at 5 1/2 inches
Embossed Layer-Rococo Rose cardstock- 5 1/4 x 4 inches
Centered Layer-Pressed Petals DSP-3 1/4 X 5 1/4 inches
Outside Border Strip-Rococo Rose cardstock-3 1/4 x 2 1/4 inches
Inside Border Strip-Pressed Petals DSP (different patterned piece)-3 1/4 x 2 inches
Banner-Noble Peacock DSP-3 1/4 x 3/4 inches
Outer Oval-Rococo Rose cardstock piece cut with Petal Labels Dies-3 x 1 3/4 inches
Inside Oval-Very Vanilla cardstock cut with Petal Labels Dies-7/8 X 2 3/4 inches